Compaq ServerNet ServerNet II Installation Manual page 108

E-6 ServerNet II PCI Adapter and Switch Installation Guide
Table E-2
SANMan Event Log Messages
Event ID
0x20 Error
0x21 Error
0x22 Error
0x23 Error
0x24 Error
0x25 Information
0x26 Error
continued
Type
Event Message: TCM component of SANMan failed during IBC initialization due to lack of
memory.
Corrective Action: Increase the physical memory. If the problem persists, contact your
service provider.
Event Message TCM component of SANMan failed during IBC initialization due to bad
source route to switch.
Corrective Action:
Verify that the X-fabric and Y-fabric Switches are correctly installed to the SAN and
powered on.
Verify the SAN Administrative node is up and running.
The node is added to the SAN with correct host name.
Check the connections and reboot.
If the problem persists, reconfigure the Switches.
Event Message: TCM component of SANMan failed during SNID validation due to bad
fabric type information.
Corrective Action: The SANMan registry entries are incorrect, reinstall the node.
Event Message: TCM component failed during initialization as we do not have an RTD
and we are unable to determine the Active SANMan.
Corrective Action:
Verify that the primary and backup Switches are powered on correctly.
Use the SANUTIL to verify the SAN configuration.
Check all SAN connections.
Event Message: TCM deinit component has been called.
Corrective Action:
Verify that the SPAD is correctly installed.
Increase the physical memory. If the problem persists, contact your service provider.
Event Message: RTD Negotiation succeeded.
Corrective Action: None
Event Message: TCM component not able to register with SPAD to receive link status
events.
Corrective Action: Check the Adapter driver (SPAD) version and that it has been started
successfully.
Event Message and Corrective Action