Table of Contents
Advertisement
where command is
DRPING, ROUTE, or AUTOSNIFF
Figure H-10. Example of Test Results Displayed in the CLI Window
Running the Echo Test in Interactive Mode
The interactive mode produces a report similar to that shown in Figure H-11.
1. Start the CLI by executing the
2. Enter the following command at the command line:
% DRPING <target>
Where
represents all nodes, or a specifically named node as follows:
target
DRPING ALL
DRPING target
Figure H-11. Echo Test Report in Interactive Mode
.
program in any standard Windows 2000 manner.
SODCLI.BAT
Targets all nodes on the SAN that are known to SANman.
Targets a specifically named node, where target represents the node,
such as:
DRPING CUPERTINO
DRPING 0xf0340
ServerNet II Diagnostics Resources H-11
Advertisement
Table of Contents
Troubleshooting
