Compaq ServerNet ServerNet II Installation Manual page 51

2-28 Compaq ServerNet II PCI Adapter and Switch Installation Guide
Steps 27-30 describe how to attach the cable(s) to the node and
test the connections.
27. Cable the X port on this end node to the X-fabric Switch.
28. Check the LED on the front or the side of the X-fabric Switch to ensure the corresponding
LED is lit.
29. (Perform Steps 29 and 30 only if there are two Switches) Cable the Y port on this end
node to the Y-fabric Switch.
30. Check the LED on the front or the side of the Y-fabric Switch to ensure the corresponding
LED is lit.
Steps 31-37 describe how to add the end node to the
SAN topology.
31. Maximize the ServerNet II Administrative Utility (SANUtil). If you have exited the
SANUtil, restart it.
32. Select Topology Configuration from the Administrative Utility screen.
NOTE: The
The
33. Right click on the port number of the node you want to configure, for example,
(node 1). This number conforms to the physical port number on the Switch. A drop-
down menu appears.
34. Select Add/PC. The Add PC Node box appears prompting you for the Node Name.
representing the Switch turns blue
is the port on the primary node, which you added in previous steps.
when you add the first Switch.