Compaq ServerNet ServerNet II Installation Manual page 117

F-4 Compaq ServerNet II PCI Adapter and Switch Installation Guide
Steps to take
Identifiers such as "PU 1, SLED 1" are used for reference in Table F-3.
SLED 1
Power on the Switch.
SLED 2
Check the Fault LED on the front of the
Switch.
SLED 3
Check port LEDS (located on the side of the
Switch by the cable connectors)
Switch LEDs
Condition Problem
All LEDs do not None
light during the
self-test the
Switch is first
powered on.
Fault LED is on. Defective Switch
Port LED not lit Loose cable
when cable is
plugged into
Incorrect cabling
Switch
End node not powered
up
End node not running
OS
Cable plugged into a
non-ServerNet II
adapter (eg. previous
version of a ServerNet
adapter or Compaq
Gigabit Ethernet)
Defective cable
Defective Adapter
PCI slot on the server is
powered off
Defective Switch
Driver has disabled the
port
Possible Solution
Normal Switch operation. No action required.
Replace the Switch.
Contact Compaq Customer Support
Check the connections on the Switch and
Adapter.
Ensure cable is plugged into the correct ports
on the Switch and Adapter.
Power up the node.
Ensure Windows 2000 is running on the end
node
Ensure cable is plugged into a ServerNet II
adapter
Replace the cable.
1. Power down the slot if the server is not PCI
Hot Plug compliant.
2. Properly seat the Adapter in the slot.
3. Replace the Adapter.
Follow the server instructions to power up the
slot.
Replace the Switch.
continued