Snetswitchaccessviolation - Compaq ServerNet ServerNet II Installation Manual

J-8 Compaq ServerNet II PCI Adapter and Switch Installation Guide

snetSwitchAccessViolation

ServerNet II Switch detected an access violation.
Specific Trap:
Severity:
Summary:
Enable:
Disable:
Returned Variable
snetSwitchSnetID
snetSwitchName
snetSwitchPortErrorStatusIndex
snetSwitchAccessViolationID
Blabbering Node
Probing Node
Switch ownership may be incorrect
105
Critical
Attempted access violation at Switch snetSwitchSnetID, (snetSwitchName), port
snetSwitchPortErrorStatusIndex by Node snetSwitchAccessViolationID.
snetSwitchAccessViolationTrapEnable = 1
snetSwitchAccessViolationTrapEnable = 0
Possible Cause
Identifies the switch that detected the error
The switch name. If no name is defined, this field will be blank.
Indicates the port that detected the error
Indicates the invalid ID which was detected
Possible Solution
Run diagnostics to ensure that nodes at both ends of the cable are
communicating properly. Replace if necessary.
A node may be trying to break into the network. Isolate the node
and verify SAN membership.
Check ownership; Cycle power on the offending switch to cause
ownership update if necessary.
Indicates