Compaq ServerNet ServerNet II Installation Manual page 111

Table E-2
SANMan Event Log Messages
Event ID Type
0x2D
0x2E
0x2F
Table E-3 shows the SnNDIS miniport driver messages.
Event ID Type
5001 Error
5005 Error
5006 Error
5009 Error
5010 Error
5031 Error
continued
Event Messages: SANMan failed to find loaded SPAD driver.
Corrective Action: Check the SPAD version and that it has been started successfully.
Event Messages: ServerNet II Port X is connected to a switch that is not X-switch.
Corrective Action: Check the ServerNet II port connections of the node.
Event Messages: ServerNet II Port Y is connected to a switch that is not Y switch.
Corrective Action: Check the ServerNet II port connections of the node.
Table E-3
SnNDIS Miniport Driver Messages
Event Message: Could not allocate the resources necessary for operation.
Corrective Action: Increase your physical memory. If the problem persists, contact your
service provider.
Event Message: Has encountered an internal error and has failed.
Corrective Action: Contact your service provider.
Event Message: The version number is incorrect for this driver.
Corrective Action: Make sure you are running a compatible version of SNNDIS on all
nodes; and, if specifying the registry value for MaximumPacketSize in the SNNDIS
parameters, that it is set to the same value on all nodes.
Event Message: Does not support the configuration supplied.
Corrective Action: Contact your service provider.
Event Message: The adapter has returned an invalid value to the driver.
Corrective Action: Contact your service provider.
Event Message: The adapter has detected an Adapter Check because of some
unrecoverable hardware or software error.
Corrective Action: Contact your service provider.
ServerNet II Event Log Messages E-9
Event Message and Corrective Action
Event Message and Corrective Action