Snetadaptrstatuschange - Compaq ServerNet ServerNet II Installation Manual

K-2 Compaq ServerNet II PCI Adapter and Switch Installation Guide

snetAdaptrStatusChange

The Adapter agent extension has detected a change in the status of the Adapter.
Specific Trap:
Severity:
Summary:
Enable:
Disable:
snetAdaptrStatus
snetAdaptrSnetID
If the status is now OK, the ports are both
OK.
The status of either the X or Y port has
changed. If the status is degraded or failed
possible causes could be a cable is not
properly connected, a broken cable, a bad
Adapter, a bad remote port.
1
Critical
Status is now %d.
snetMibStatusTrapEnable = 1
snetMibStatusTrapEnable = 0
Returned Variable
Possible Cause
Indicates
Identifies the current Adapter device status
Identifies the ServerNet II ID of the Adapter
Possible Solution
None needed.
Determine which port is down. Check the cable to make
sure it is properly connected at both ends. Swap out the
cable. Swap the Adapter.