Compaq ServerNet ServerNet II Installation Manual page 118

Switch LEDs
continued
Steps to take
SLED 4
Check X and Y LEDs on the front of the
Switch
Steps to take
Ensure the configuration is
correct.
Condition
Both LEDs are
off
-or-
both are on
Wrong fabric
LED is on (X is
on when you
expect Y or vise
versa)
Configuration
Condition
Installation does not
match configuration.
Problem
Fault with X or Y 1.Check the configuration.
configuration
2.Reconfigure the Switch with SANUtil.
Defective Switch Replace the Switch.
Contact Compaq Customer Support.
Fabric miscabled 1.Correct fabric cabling to insure the Adapter X
port is connected to the X-fabric Switch.
2.Reconfigure the Switch topology with
SANUtil.
Problem
Configuration was Correct the configuration.
not done correctly.
Correct the network design.
Mis-entered See SANUtil.
information in the
configuration utility
(SANUtil).
Mis-entered in the See CONFIG.
configuration wizard
(CONFIGWIZ).
ServerNet II Troubleshooting F-5
Possible Solution
Possible Solution