Compaq ServerNet ServerNet II Installation Manual page 119

F-6 Compaq ServerNet II PCI Adapter and Switch Installation Guide
Steps to take
Identifiers such as "PU 1, SLED 1" are used for reference in Table F-3.
D 1
Ensure Diagnostics tests are
running
D 2
Run topology test (which checks
that the SAN cabling is as
configured) and check results.
D 3
Run echo test (which checks the
server-to-server connections)
and check results.
D 4
Run router test (which checks
the server-to-Switch connection)
and check results.
Diagnostics
Condition
Diagnostics isn't running
Topology test fails.
Echo test fails after
topology test passes.
Router test fails after
topology test passes.
Problem
Diagnostics not If a test will not run, reinstall Diagnostics.
properly installed or
has been corrupted.
Crossed fabric (X orrect cabling.
Adapter port to Y
Switch)
Switch port connected Correct cabling.
to wrong end node
End node is not Configure end node in the SAN using SANUtil.
configured.
Switch port connected Correct the configuration.
to wrong end node.
Switch not configured Configure the Switch in the SAN using SANUtil.
in the SAN.
Two SANs Ensure cables stay within one Switch and one
inadvertently fabric.
connected to
ServerNet II
Switch not powered See Table F-2 "Power Up" section.
up
Loose cable See Table F-2 "Power Up" section.
Improper See Table F-2 "Configuration" section.
configuration
Defective Switch. Replace Switch.
Configuration is wrong See Configuration section in this table.
Driver is not OK. Reinstall drivers.
Contact Compaq Customer Support.
Possible Solution
continued