Olympus FLUOVIEW FV1000 User Manual page 381

Among the multiple image slices composing the XYZ image, the range of image slices to be
used in extend image building can be specified.
1. Display the image slice to be set as the start image by using the <Frame advance> or
2. Click the <Set start position> button at the top of the image window.
<Set start position>
button
3. Display the image slice to be set as the end image by using the <Frame advance> or
4. Click the <Set end position> button at the top of the image window.
<Set end position>
button
NOTE
NOTE
APPLIED OPERATIONS
<Successive display> buttons at the top of the image window.
<Successive display> buttons at the top of the image window.
The <Set start position> and <Set end position> buttons are valid in the
pushed-in condition. To cancel a previously set start or end position, click
the <Set start position> or <Set end position> button again.
When it is required to analyze the built extended-focus image or save it in
the Fluoview Multi Tiff format, create the extended-focus image as a
separate image from the original image. See section 2-8-1-2, "Turning
Built Image into Single Image".
/Building an Image from a Different Viewpoint
OPERATION INSTRUCTIONS
Page
2 - 2 9 7