Olympus FLUOVIEW FV1000 User Manual page 128

APPLIED OPERATIONS
5 Setting the interval time
Set the interval time using the <
< > button or by input from the
keyboard.
Set the number of scans using the <
or < > button or by input from the
keyboard. Under text box, it displays
max. number of slices that can be
acquired with use of physical memory
only available at that time.
Shows the time after end of acquisition
of an image until the start of next
acquisition.
Shows the total time required for image
acquisitions.
6 Setting the number of scans
OPERATION INSTRUCTIONS
Page
2 - 4 4
/Image Acquisition
1. From the page tabs on the bottom right of the [Acquire] panel, select the [Time Series]
sub-panel.
2. Set the interval time using the <
[Interval] text box
> or
[N] text box
>
[Rest Time] text box
[Total Time] text box
Fig. 2-15 [Time Series] Sub-panel
TIP
An image with no interval can be acquired by entering [0] in the [Interval] text
box.
In this case, the [Interval] text box shows "Free Run" message.
Using < > button also sets the [Interval] text box to "Free Run".
2. Set the number of scans using the <
Series] sub-panel.
> or < > button in the [Interval] text box.
> or < > button in the [N] text box in the [Time