Olympus FLUOVIEW FV1000 User Manual page 142

APPLIED OPERATIONS
2 Setting the numbers of steps and acquired image slices
[Step Size] text box
[Slices] text box
3 Setting the observation mode
4 Setting the interval time
OPERATION INSTRUCTIONS
Page
2 - 5 8
/Image Acquisition
1. Set the number of steps using the <
TIP
The number of steps shown in the [Step Size] text box has been calculated by
the system so that the depth scale of the acquired image is identical to the
horizontal scale.
TIP
The number of acquired images shown in the [Slices] text box can also be input
from the keyboard.
After setting [Start Z] (Z-direction scan start position) and [Stop Z] (Z-direction
scanning stop position), input the desired number of images in the [Slices] text
box. This automatically sets [Step Size] (number of steps).
1. In the [Mode] group box in the [Acquire] panel, select the [Surface] option button.
2. In the [Acquire] panel, select the XYZT observation mode option button.
1. From the page tabs on the bottom right of the [Acquire] panel, select the [Time Series]
sub-panel. A panel as shown below will be displayed.
Fig. 2-19 [Time Series] Sub-panel
> or < > button in the [Step Size] text box.
[Interval] text box
Set the interval time using the <
or < > button or by input from the
keyboard.
[N] text box
Set the number of scans using the
< > or < > button or by input
from the keyboard. Under text box,
it displays max. number of slices
that can be acquired with use of
physical memory only available at
that time.
[Rest Time] text box
Shows the time after end of
acquisition of an image until the
start of next acquisition.
[Total Time] text box
Shows the total time required for
image acquisitions.
>