Olympus FLUOVIEW FV1000 User Manual page 192

APPLIED OPERATIONS
6 Setting the TIME COURSE Software (optional)
OPERATION INSTRUCTIONS
Page
2 - 1 0 8
/Image Acquisition
3. From the page tabs on the bottom right of the [Acquire] panel, select the [Time Series]
sub-panel. The panel as shown below appears.
Fig. 2-27 [Time Series] sub-panel
4. Set the interval time to "10" using the <
Change the interval time corresponding to the specimen.
5. Set the number of scans to "30" using the <
the [Time Series] sub-panel. Change the number of scans corresponding to the
specimen.
6. Confirm that the time for image acquisition is set to 5 minutes (or 300 seconds) in the
[Total Time] text box. The time for image acquisition differs according to the interval
and the number of scans.
Setting of the real time graph is required when you use the TIME COURSE software.
See the "FV-TIEMPO TIME COURSE software User's manual" for details of the TIME
COURSE software.
[Interval] text box
Set the interval with the <
buttons. Key entry is also acceptable.
[N] text box
Set the number of scans with the <
and < > buttons. Key entry is also
acceptable.
Under text box, it displays max. number
of slices that can be acquired with use
of physical memory only available at
that time.
[Rest Time] text box
Shows the time after the end of an
image acquisition until the start of next
acquisition
[Total Time] text box
Shows the time required to complete image
acquisition.
> and < > buttons in the [Interval] text box.
> and < > buttons in the [N] text box in
> and< >
>