Olympus FLUOVIEW FV1000 User Manual page 171

8.
<XY Repeat> button
<Focus> button
9.
10. Click the <STOP SCAN> button to stop repeated scanning.
11. Repeat steps 7 and 10 for each of the groups to be configured.
12. Click the <Seq. Once> button to start sequential scan.
<Seq Once> button
13. After image acquisition, click <Normal> below the [Surface XY] option button in the
Click the <XY Repeat> or <Focus> button to perform repeated scanning in order to
adjust the brightness of the channels.
TIP
TIP
Select a group before repeated scanning. The group selection cannot be
changed during repeated scanning.
Adjust the brightness using the [PMT], [Offset] and [Gain] LED sliders in the [Ch] group
box in the [Acquire] panel. For details, see section 2-2-1-4-9, "Adjusting the image
brightness".
[Mode] group box in the [Acquire] panel to return from the image acquisition mode.
This hides the virtual channels from the display.
TIP
Only the image(s) of the current Sequential Group is updated when image is
acquired by pressing <XY Repeat> button or <Focus>. The other Sequential
Group image stays in [Live] panel.
APPLIED OPERATIONS
OPERATION INSTRUCTIONS
Page
/Image Acquisition
2 - 8 7