FINAL DRIVE
PROPSHAFT U-JOINT SERVICE
PROPSHAFT U-JOINT DISASSEMBLY
NOTICE
Before servicing the prop shaft U-joint, be sure the joint
is clean to ensure no debris damages the yoke.
1. With the prop shaft removed and marked for
alignment orientation, remove the retaining rings
from both sides of the yoke.
2. Using a commercially available Ball Joint / U-Joint
Press Set, place a receiving cup adapter
larger ID than the U-joint cap OD on one end.
8.16
3. Place a remover adapter
with a smaller OD than the U-joint cap.
q
4. Position clamp
remover adapter.
w
with a
5. Tighten clamp with hand tools to force U-joint cups
out of yoke.
6. Discard and replace all U-joint parts that were
removed from the yoke.
e
on other end of U-joint
r
over receiving cup adapter and
9850045 R01 - 2020-2021 RANGER 1000 Service Manual
© Copyright Polaris Inc.