Support Bearing Replacement; U-Joint Disassembly - Polaris RZR PRO XP 2020 Service Manual

Hide thumbs Also See for RZR PRO XP 2020:

Table of Contents

SUPPORT BEARING REPLACEMENT

1. Remove front prop shaft from the vehicle (see Prop

Shaft Removal / Installation page 8.21).

2. Using a hydraulic press, remove support bearing and

isolator bearing support as an assembly.

3. Clean the bearing mounting surface on the shaft.

4. Install new support bearing and isolator bearing

support assembly onto the end of the prop shaft.

5. Using a hydraulic press, install the support bearing

assembly onto the prop shaft.

The notch on the bearing support should be oriented as

6. Install front prop shaft into the vehicle (see Prop Shaft

Removal / Installation page 8.21).

Always wear eye protection.

9850068 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual

1. Remove external snap ring

If yoke or bearing is removed, cross bearing must be

replaced. Note orientation of grease fitting (if equipped)

and mark inner and outer yoke for correct re-positioning

during installation.

2. Support inner yoke as shown and drive outer yoke

down (bearing cap out) with a suitable press.

from all four bearing

Table of Contents