Concluding Steps; Replacing An Expansion Card - Fujitsu PRIMERGY RX2530 M4 Upgrade And Maintenance Manual

9.5.2.4

Concluding steps

Ê Install the corresponding riser module, see section
on page 68.
"Reassembling" on page 57
Ê
"Connecting the power cord" on page 63
Ê
"Switching on the server" on page 66
Ê
Ê If applicable, update the system information of your server using the Chassis
ID Prom Tool, see section
Select the corresponding system name (for example "at OCULink Onboard"
or "at Retimer...").
"Resuming BitLocker functionality" on page 98
Ê
9.5.3

Replacing an expansion card

Upgrade and Repair Unit
(URU)
Tools: slot 1: Phillips PH2 / (+) No. 2 screw driver
slot 2, slot 3, slot 4: tool-less
Note on network settings recovery
I
When replacing network controllers or the system board, network
configuration settings in the operating system will be lost and replaced
by default values. This applies to all static IP address and LAN teaming
configurations.
Ensure to note down your current network settings before replacing a
network controller or the system board.
RX2530 M4
"Using the Chassis ID Prom Tool" on page
Upgrade and Maintenance Manual
Expansion cards and backup units
"Installing a riser module"
Hardware: 10 minutes
Software: 5 minutes
103.
233