Removing 2.5-Inch Hdd/Ssd Modules; Preliminary Steps - Fujitsu PRIMERGY RX2530 M4 Upgrade And Maintenance Manual

7.4.5

Removing 2.5-inch HDD/SSD modules

Customer Replaceable Unit
(CRU)
Tools: tool-less
7.4.5.1

Preliminary steps

Ê If the HDD/SSD module to be removed is combined into a RAID array,
please proceed as follows:
RAID level Procedure
RAID 0
RAID 1
RAID 5
In order to permanently remove an operational HDD/SSD module that is part
of a RAID array from the server, you first need to delete the array using
ServerView RAID Manager.
V
CAUTION!
All data on all HDDs/SSDs in the array will be lost when deleting the
RAID array! Be sure to back up your data before deleting a RAID
array.
For more information, see the "ServerView Suite RAID Management"
user guide.
RX2530 M4
Hard disk drive (HDD) / solid state drive (SSD)
V
CAUTION!
RAID 0 provides no data redundancy.
In case of an HDD/SSD module is defect, all data
are lost!
Removing an HDD/SSD module from a RAID 1 or RAID 5
array will not result in data loss.
However, the removed drive needs to be replaced
immediately by an HDD/SSD module of the same or larger
capacity.
I
After replacing the HDD/SSD module, RAID
rebuild will be performed as a background
process, see section
rebuild" on page
Upgrade and Maintenance Manual
Hardware: 5 minutes
"Performing a RAID array
99.
159