Fujitsu PRIMERGY RX2530 M4 Upgrade And Maintenance Manual page 366

System board and components
16.1 Basic information
This section provides instructions for the system board and the following
components:
CMOS battery
●
The real-time clock is powered by a lithium coin cell (CMOS battery) when
mains get lost. This cell lasts up to five years, depending on ambient
temperature and use.
If the CMOS battery is depleted or falls below minimum voltage levels, it
need to be replaced immediately.
TPM (Trusted Platform Module)
●
The system board is optionally equipped with a TPM. This module enables
programs from third party manufacturers to store key information, for
example drive encryption using Windows Bitlocker Drive Encryption.
iRMC microSD card
●
The iRMC microSD card is necessary for using the embedded Lifecycle
Management (eLCM) functionality of the iRMC.
M.2 SSD
●
The system board offers two M.2 slots (Key M) with support for 42 mm,
60 mm, 80 mm and 110 mm long M.2 SSDs. With the M.2 SSD an internal
SSD is offered. This SSD can be configured as a boot device or data storage
device.
Dual microSD 64GB Enterprise
●
The system board is optionally equipped with a Dual microSD 64GB
Enterprise. The Dual microSD 64GB Enterprise offers an Integrated
Hardware RAID solution based on RAID-on-Chip (ROC) technology.
366 Upgrade and Maintenance Manual
RX2530 M4