Concluding Steps - Fujitsu PRIMERGY RX2530 M4 Upgrade And Maintenance Manual

Hard disk drive (HDD) / solid state drive (SSD)
Figure 87: Connecting the cables to the ODD and the 4x 2.5-inch HDD backplane
Ê If applicable, push the ODD in its bay until the ODD latch engages (see
orange arrow).
Ê Connect the following cables to the ODD and the HDD backplane:
– (1) power cable to ODD (if applicable)
– (2) SATA cable to ODD (if applicable)
– (3) SAS cable to connector "X5" on the HDD backplane
– (4) power cable to connector "PWR (X10)" on the HDD backplane
I
If applicable, connect the OOB cable to connector "SMBus" on the
HDD backplane (see figure 84).
For the cable plan, see chapter

7.4.11.4 Concluding steps

Ê Insert all HDD/SSD modules, see section
module" on page
I
Make sure that you reinstall the HDD/SSD module in the bay it was
located before the HDD backplane replacement.
Ê Insert all dummy modules, see section
dummy module" on page
"Reassembling" on page 57
Ê
"Connecting the power cord" on page 63
Ê
"Switching on the server" on page 66
Ê
174
"Appendix B" on page
157.
160.
Upgrade and Maintenance Manual
437.
"Installing a 2.5-inch HDD/SSD
"Installing a 2.5-inch HDD/SSD
RX2530 M4