Installing The New 3.5-Inch Hdd Backplane - Fujitsu PRIMERGY RX2530 M4 Upgrade And Maintenance Manual

Hard disk drive (HDD) / solid state drive (SSD)
7.3.5.3

Installing the new 3.5-inch HDD backplane

Figure 63: Installing the 3.5-inch HDD backplane
Ê Position the HDD backplane on the three hooks (see circles).
Ê Push the HDD backplane downward. Make sure that the HDD backplane fits
into the guides (A).
V
CAUTION!
Ensure that none of the cables are strained or damaged!
Figure 64: Connecting the cables to the 3.5-inch HDD backplane
Ê Connect the following cables to the HDD backplane:
– SAS/SATA data cable:
(1), (2), (4), (5) to connectors "P4", "P3", "P2", "P1" according to the
length
(6) plug P6 to connector "SGPIO"
– (3) power cable to connector "X12"
I
If applicable, connect the OOB cable to connector "SMBus" on the
HDD backplane (see figure 61).
For the cable plan, see chapter
146
"Appendix B" on page
Upgrade and Maintenance Manual
437.
RX2530 M4