Enabling The Boot Watchdog - Fujitsu PRIMERGY RX2530 M4 Upgrade And Maintenance Manual

Basic software procedures
I
<CPU#> parameters are "0" for CPU 1 and "1" for CPU 2.
Ê If the error status cannot be reset with the method above, please use the
following procedure for resetting the error counter of all CPUs:
Ê Log in as root.
Ê Enter the commands below, followed by [ENTER]:
1. /etc/init.d/srvmagt stop
/etc/init.d/srvmagt_scs stop
/etc/init.d/eecd stop
/etc/init.d/eecd_mods_src stop
2. cd /etc/srvmagt
3. rm -f cehist.bin
4. /etc/init.d/eecd_mods_src start
/etc/init.d/eecd start
/etc/init.d/srvmagt start
/etc/init.d/srvmagt_scs start
Ê Ensure that all pre-fail/fail status issues have been resolved in ServerView
Operations Manager.
5.2.8

Enabling the boot watchdog

If the boot watchdog has been disabled for firmware upgrade purposes (see
section "Disabling the boot watchdog" on page
complete the maintenance task.
Timer settings can be configured in the BIOS or using the ServerView iRMC
web interface.
Enabling the boot watchdog in the BIOS
Ê Enter the BIOS.
Ê Select the Server Mgmt menu.
Ê Under Boot Watchdog set the Action setting to Reset.
Ê Save your changes and exit the BIOS.
92 Upgrade and Maintenance Manual
78), it has to be re-enabled to
RX2530 M4