Fujitsu PRIMERGY RX2530 M4 Upgrade And Maintenance Manual page 350

Front panel
14.3.1.3 Installing the front VGA board
Figure 261: Installing the front VGA board
Ê Push the front VGA connector in the corresponding recess (1) and fasten the
front VGA board with two screws (2).
Ê Route the cable tie under the front VGA board (3).
14.3.1.4 Concluding steps
"Installing the front panel module" on page 346
Ê
"Reassembling" on page 57
Ê
"Connecting the power cord" on page 63
Ê
"Switching on the server" on page 66
Ê
14.3.2 Removing the front VGA board
Upgrade and Repair Unit
(URU)
Tools: Phillips PH1 / (+) No. 1 screw driver
14.3.2.1 Preliminary steps
"Shutting down the server" on page 49
Ê
350 Upgrade and Maintenance Manual
Hardware: 10 minutes
RX2530 M4