Concluding Steps - Fujitsu PRIMERGY RX2530 M4 Upgrade And Maintenance Manual

Expansion cards and backup units
Figure 148: Example - Retimer controllers in riser module 2 and 3
Ê Connect the VPP cable from the first Retimer controller in riser module 2 to
connector "VPP CPU1" on the system board.
Ê Connect the color-coded Oculink cables to the corresponding HDD
backplane (see section
page 175).
9.5.1.4

Concluding steps

Ê Install the corresponding riser module, see section
on page 68.
"Reassembling" on page 57
Ê
"Connecting the power cord" on page 63
Ê
"Switching on the server" on page 66
Ê
Ê If applicable, update the system information of your server using the Chassis
ID Prom Tool, see section
Select the corresponding system name (for example "at EP5x0i").
"Updating expansion card firmware" on page 85
Ê
"Enabling Option ROM scan" on page 86
Ê
"Resuming BitLocker functionality" on page 98
Ê
230
"Replacing a 10x 2.5-inch HDD backplane" on
"Using the Chassis ID Prom Tool" on page
Upgrade and Maintenance Manual
"Installing a riser module"
RX2530 M4
103.