Fujitsu PRIMERGY RX2530 M4 Upgrade And Maintenance Manual page 176

Hard disk drive (HDD) / solid state drive (SSD)
PCIe configuration onboard connected only
Label color on the
color-coded
Oculink cable
red
yellow
OOB cable plug
PCIe configuration with 1x Retimer controller in riser module 2 (slot 3)
Label color on the
color-coded
Oculink cable
red
yellow
green
black
OOB cable plug
)
* Depending on firmware of iRMC S5 and revision of Combo backplane (see
figure 88 and figure 89):
P2: iRMC S5 firmware FW ≥ 1.25P, backplane revision ≥ D, Chassis-ID
custom Infofield0 = R8
P3: backplane revision ≥ C, Chassis-ID custom Infofield0 = RB
I
Example of connecting OOB cable, see figure
100 (shows P3).
176
Connector on the
system board
PCIe 0
PCIe 1
Connected to
system board
P1
Connector on the
Retimer controller
Port 0
Port 1
Port 2
Port 3
Connected to
system board
P1
Upgrade and Maintenance Manual
Connector on the
10x 2.5-inch HDD backplane
X1A
X2A
Connected to
10x 2.5-inch HDD backplane
P2
Connector on the
10x 2.5-inch HDD backplane
X1A
X2A
X3A
X4A
Connected to
10x 2.5-inch HDD backplane
)
P2 or P3 *
99 (shows P2) and figure
RX2530 M4