Fujitsu PRIMERGY RX2530 M4 Upgrade And Maintenance Manual page 382

System board and components
16.4.3.1 Preliminary steps
"Locating the defective server" on page 47
Ê
"Shutting down the server" on page 49
Ê
"Disconnecting the power cord" on page 50
Ê
"Getting access to the component" on page 52
Ê
Ê If applicable, remove the riser module 3, see section
module" on page
16.4.3.2 Replacing the iRMC microSD card
Ê Remove the defective iRMC microSD card, see section
iRMC microSD card" on page
V
CAUTION!
The iRMC microSD card contains customer information. After
replacing the iRMC microSD card, hand the defective card over to the
customer. If the customer requests disposal of the defective iRMC
microSD card, proceed as follows:
Ê Using a pair of side-cutting pliers, cut the iRMC microSD card in
half.
Ê Install the new iRMC microSD card, see section
microSD card" on page
16.4.3.3 Concluding steps
Ê If applicable, install the riser module 3, see section
on page 68.
"Reassembling" on page 57
Ê
"Connecting the power cord" on page 63
Ê
"Switching on the server" on page 66
Ê
382
68.
380.
379.
Upgrade and Maintenance Manual
"Removing a riser
"Removing the
"Installing the iRMC
"Installing a riser module"
RX2530 M4