Looking For The Wwn Address Of A Fibre Channel Controller - Fujitsu PRIMERGY RX2530 M4 Upgrade And Maintenance Manual

Ê In the Ethernet Ports group, you will find detailed information on each
network controller in the managed PRIMERGY server, including its MAC
address.
I
This information is only available with the iRMC S5 or above.
Only network controllers supporting the Command Line Protocol
(CLP) will be displayed.
I
For add-in cards the vendors provide documentation and tools, offered
on the Fujitsu support web pages:
http://ts.fujitsu.com/support/
Select the server, select Downloads - More Details - Driver.
Some vendors bundle the documentation together with the driver
package.
Using the vendor tools in a Legacy BIOS
Ê Enter the BIOS setup menu.
Ê Select the Advanced menu.
Ê Under CSM Configuration set the Boot option filter to Legacy only.
Ê Save your changes and exit the BIOS.
Ê Reboot your system.
Your system will now start with Legacy Boot.
When starting your system with Legacy Boot, the different vendor tools will be
displayed on the screen.
Ê Press the required key to enter into the vendor tool.
Ê Step forward to get access to the address of interest.

5.2.16.2 Looking for the WWN address of a fibre channel controller

There are several possible locations where these addresses can be found.
Ê Inform the customer about the new or changed WWN address.
Checking the label
Ê If available, check the label on the controller.
Beside the part number, you may find the WWN address.
RX2530 M4
Upgrade and Maintenance Manual
Basic software procedures
101