Expansion cards and backup units
9.6.4.2
Removing the FBU with the holder
Figure 186: Removing the FBU with the holder
Ê Lift up the green locking handle on the holder (see circle) while sliding the
holder in direction of the arrow as far as it will go.
I
After that, the shoulder screw caps on the riser module will rest in the
wide ends of the keyhole slots on the holder.
Ê Lift the holder out of the riser module 3.
9.6.4.3
Disconnecting the FBU cable from the FBU
Ê Disconnect the FBU cable from the FBU (see figure 184).
9.6.4.4
Removing the FBU from the holder
Ê Pull the FBU at a slight angle out of the holder (see figure 185).
9.6.4.5
Concluding steps
Ê Install the riser module 3, see section
"Reassembling" on page 57
Ê
"Connecting the power cord" on page 63
Ê
"Switching on the server" on page 66
Ê
266
Upgrade and Maintenance Manual
"Handling riser modules" on page
67.
RX2530 M4