Expansion cards and backup units
9.5.8.2
Installing the upgrade kit
Figure 166: Removing the riser module support
Ê Remove the screw (1).
Ê Remove the riser module support (2).
Ê Remove the riser card from riser module 3, see section
defective riser card" on page
Figure 167: Installing the riser card - example full height riser module
Ê Insert the riser card (1).
Ê Fasten the riser card with two screws (2).
Ê If applicable, install a full height slot bracket to the expansion card, see
section
"Installing a slot bracket" on page
250
243.
Upgrade and Maintenance Manual
"Removing the
204.
RX2530 M4