Fujitsu PRIMERGY RX2530 M4 Upgrade And Maintenance Manual page 329

Ê Choose the memory slot according to the configuration rules, see section
"Basic information" on page
12.4.1.3 Installing a memory module
Ê Pull up the required memory cover(s), see figure
Figure 237: Opening the memory cooling units
Ê Open the required memory cooling unit:
– Swing the left/right memory cooling unit(s) in the direction of the pump
(see arrows).
– Swing the central memory cooling unit in the direction of the arrow.
Ê Install the memory module, see section
page 281.
Ê If applicable, install the memory spacers, see section
spacer" on page
Ê Close the required memory cooling unit(s).
Ê Position the memory cover(s) over the memory modules and press them
carefully down, see figure
12.4.1.4 Concluding steps
"Reassembling" on page 57
Ê
"Disconnecting the power cord" on page 50
Ê
RX2530 M4
270.
332.
232 on page
Upgrade and Maintenance Manual
Liquid cooling (LC)
218 on page
"Installing a memory module" on
"Installing a memory
323.
312.
329