7.3.4.1
Preliminary steps
"Locating the defective server" on page 47
Ê
"Locating the defective component" on page 48
Ê
7.3.4.2
Removing the defective 3.5-inch HDD module
Ê Remove the HDD module, see section
on page
141.
Ê If applicable, remove the HDD from the installation frame, see section
"Handling HDDs or SSDs without installation frame" on page
7.3.4.3
Installing the new 3.5-inch HDD module
Ê If applicable, install the HDD in the installation frame, see section
HDDs or SSDs without installation frame" on page
Ê Install the HDD module, see section
page
139.
7.3.4.4
Concluding steps
Ê If the HDD is configured using a RAID controller with a RAID level higher
than "0", the rebuild will start automatically, see section
array rebuild" on page
RX2530 M4
Hard disk drive (HDD) / solid state drive (SSD)
99.
Upgrade and Maintenance Manual
"Removing a 3.5-inch HDD module"
131.
"Installing a 3.5-inch HDD module" on
131.
"Handling
"Performing a RAID
143