Fujitsu PRIMERGY RX2530 M4 Upgrade And Maintenance Manual page 397

16.6.4 Replacing the microSD card
Upgrade and Repair Unit
(URU)
Tools: a pair of side-cutting pliers
16.6.4.1 Preliminary steps
"Locating the defective server" on page 47
Ê
"Shutting down the server" on page 49
Ê
"Disconnecting the power cord" on page 50
Ê
"Getting access to the component" on page 52
Ê
"Removing the air duct" on page 73
Ê
16.6.4.2 Replacing the microSD card
Ê Remove the Dual microSD 64GB Enterprise, see section
Dual microSD 64GB Enterprise" on page
Ê Remove the defective microSD card from the Dual microSD 64GB
Enterprise. Proceed as described in the following:
Ê To eject the defective microSD card, gently push it in and then let go (see
figure 298).
Ê Pull the microSD card straight out of its slot.
V
CAUTION!
The microSD card contains customer information. After replacing the
microSD card, hand the defective card over to the customer. If the
customer requests disposal of the defective microSD card, proceed
as follows:
Ê Using a pair of side-cutting pliers, cut the microSD card in half.
RX2530 M4
Upgrade and Maintenance Manual
System board and components
Hardware: 5 minutes
"Removing the
394.
397