Fujitsu PRIMERGY RX2530 M4 Upgrade And Maintenance Manual page 372

System board and components
Ê Fasten the TPM with the special screw for the TPM using the TPM bit insert
or TPM module fixing tool (Japan) (2).
V
CAUTION!
Do not fasten the screw too firmly. Stop it by extent where the head
of the screw lightly touches the TPM (torque value of 0.6 Nm, the
description of this torque value doesn't apply to Japan).
16.3.1.3 Concluding steps
Ê If applicable, install the riser module 2, see section
on page 68.
"Reassembling" on page 57
Ê
"Connecting the power cord" on page 63
Ê
"Switching on the server" on page 66
Ê
"Resuming BitLocker functionality" on page 98
Ê
Ê Enable TPM in the system board BIOS. Proceed as follows:
Ê Switch on or restart your server.
Ê As soon as the startup screen appears, press the [F2] function key to
enter the BIOS.
Ê Select the Advanced menu.
Ê Select the Trusted Computing submenu.
Ê Set the TPM Support and TPM State settings to Enabled.
Ê Under Pending TPM operation, select the desired TPM operation
mode.
Ê Save your changes and exit the BIOS.
I
For information on how to access the BIOS and modify settings, see
the corresponding BIOS Setup Utility reference manual.
372 Upgrade and Maintenance Manual
"Installing a riser module"
RX2530 M4