Fujitsu PRIMERGY RX2530 M4 Upgrade And Maintenance Manual page 330

Liquid cooling (LC)
"Switching on the server" on page 66
Ê
"Resuming BitLocker functionality" on page 98
Ê
12.4.2 Removing a memory module
Upgrade and Repair Unit
(URU)
Tools: Phillips PH2 / (+) No. 2 screw driver (for the riser module)
12.4.2.1 Preliminary steps
"Suspending BitLocker functionality" on page 77
Ê
"Shutting down the server" on page 49
Ê
"Disconnecting the power cord" on page 50
Ê
"Getting access to the component" on page 52
Ê
12.4.2.2 Removing a memory module
Ê Pull up the required memory cover(s), see figure
Ê Open the required memory cooling unit, see figure
– Swing the left/right memory cooling unit(s) in the direction of the pump
(see arrows).
– Swing the central memory cooling unit in the direction of the arrow.
Ê If applicable, remove the memory spacers.
Ê Remove the memory module, see section
page 284.
Ê If applicable, install the memory spacers, see section
spacer" on page
Ê Close the required memory cooling unit(s).
Ê Position the memory cover(s) over the memory modules and press them
carefully down, see figure
330
332.
232 on page
Upgrade and Maintenance Manual
Hardware: 5 minutes
218 on page
237 on page
"Removing a memory module" on
"Installing a memory
323.
312.
329.
RX2530 M4