Resuming Bitlocker Functionality - Fujitsu PRIMERGY RX2530 M4 Upgrade And Maintenance Manual

Basic software procedures
Ê For the changes to take effect, you need to reboot the network by entering
the following command:
# service network restart
I
If the system board or network controller offers multiple LAN ports, it is
necessary to update the remaining ifcfg-eth<x> definition files
accordingly.
Ê Update the NIC configuration file to reflect the new card sequence and MAC
address.

5.2.14 Resuming BitLocker functionality

If BitLocker Drive Encryption has been suspended for maintenance purposes
(see section "Suspending BitLocker functionality" on page
enabled to complete the service task.
I
If BitLocker Drive Encryption has been suspended prior to replacing
components you won't be asked for a recovery key when rebooting the
server after the maintenance task. However, if BitLocker functionality has
not been suspended, Windows will enter recovery mode and ask you to
input recovery key for further booting.
Ê In this case, ask the system administrator to enter the recovery key in
order to boot the operating system.
Ê Ask the system administrator to enable the previously suspended BitLocker-
protection on the system volume, using the BitLocker Drive Encryption
control panel item:
Ê Click Start - Control Panel - System and Security - BitLocker Drive
Encryption to open the BitLocker Drive Encryption.
Ê Select the system volume, and click Resume Protection.
I
For more information on how to resume BitLocker drive encryption, see
the Microsoft TechNet library at
http://technet.microsoft.com/library/cc731549.aspx.
For more information, see the Fujitsu web pages.
98 Upgrade and Maintenance Manual
77), it has to be re-
RX2530 M4