Setting Computation Channels - Omega RD-MV100 Series User Manual

11.4 Setting Computation Channels

Procedure
11-10
This section describes the procedures to set equations to computation channels. The
equation is set in the setting mode. Equations cannot be set while data acquisition or
computation is in progress.
• These procedures are carried out in the setting mode.
• Use the arrow keys to move the cursor (blue) to the appropriate parameter. (The
parameters that cannot be changed are grayed).
• The possible selections are displayed at the bottom of the screen. Select using the
soft keys.
• The parameter boxes that are changed are displayed in yellow. By confirming the
new settings, they change back to white.
Press MENU .
Twice press the soft key
To display the setting screen press the soft key
1
4
The numbers in front of the operating procedure shown below correspond to the
numbers in the above figure.
1. First channel and last channel
Select the desired channels.
2. Math On/Off
If On is selected a box used to enter the equation will appear. When not using
computation, select Off.
3. Calculation expression
Enter the equation (up to 40 characters).
Pressing the [Input] soft key displays a window used to enter an equation. Enter
the equation using the following key operations and press the DISP/ENTER key.
For writing equations, see "Rules for writing an equation (common items)" in
section11.2.
Next 1/3
.
2
3
5
#9
.