Omega RD-MV100 Series User Manual page 66

3.3 Inserting/Removing the External Storage
Medium
This section describes the procedures to insert and remove the external storage
medium. Three types of media can be used depending on the specification.
• Model RD-MV1
• Model RD-MV1
• Model RD-MV1
For the handling procedure of the storage medium, see section 2.1.
Procedure
Inserting the storage medium
1.
2.
Note
Removing the storage medium
Floppy disks and ATA flash memory cards can be removed from the drive regardless of
whether the RD-MV100 is turned ON or OFF. Zip disks cannot be removed when the
RD-MV100 is turned OFF.
1.
Note
•
•
-1: Floppy disk
-2: Zip disk
-3: ATA flash memory card
Insert the medium into the drive until a click is heard.
When the power switch is turned ON, closing the front cover causes the RD-
MV100 to detect the existence of an external storage medium in the drive. If the
storage medium is detected, an external storage medium icon is displayed in the
status display section of the screen.
The external storage medium can't be detected when the MEDIA key is locked. First release
the MEDIA key and then press it. (See 10.2 Using key lock.)
Floppy disk
If the RD-MV100 is turned ON, check that the storage medium is not being
accessed.
The access lamp is lit while the storage medium is being accessed.
A message "Data are being saved to the medium." is displayed while measured/computed
data are being saved to the medium.
Zip disk ATA flash memory card
3
3-5