Omega RD-MV100 Series User Manual page 131

6.4 Setting the Auxiliary Alarm Function (Basic
Setting Mode)
Procedure
6-10
Set the auxiliary alarm function.
• These procedures are carried out in the basic setting mode.
• Use the arrow keys to move the cursor (blue) to the appropriate parameter.
• The possible selections are displayed at the bottom of the screen. Select using the
soft keys.
• The parameter boxes that are changed are displayed in yellow. Once new settings
are confirmed, they change back to white.
Press MENU .
Press FUNC for 3 seconds. The menu screen for the basic setting mode appears.
To display the setting screen press the soft key
The numbers in front of the operating procedure shown below correspond to the
numbers in the above figure.
Setting reflash
*
1. Reflash
Select [On] or [Off].
On : Use reflash function
Off : Not use reflash function
Setting the AND/OR logic of output relays
*
2. Relay - AND
Select the relays that are to use the AND logic. Set the last relay that is to use
the AND logic. The relays beyond this relay will use the OR logic.
Select from [None], [I01] (I01 only), [I01 - I02] (I01 and I02), ... , and [I01 - I06]
(I01 to I06). The setting is valid for relays specified by options.
Setting the output relay operation (energized/de-energized)
*
3. Relay - Action
Select energize or de-energize using the soft key.
Setting the output relay operation (hold/non-hold)
*
4. Relay - Behavior
Select hold or non-hold using the soft key.
* When the alarm output relay option is not installed, these settings are void.
Setting the alarm indication operation (hold/non-hold)
5. Indicator
Select hold or non-hold using the soft key.
#1
.
1
2
3
4
5
6
7