Omega RD-MV100 Series User Manual page 110

5.3 Digital Input (DI) Setting
To measure the digital input (ON/OFF input), follow the procedures below to set the input
range. The range cannot be changed while data acquisition or computation is in
progress.
Procedure
• These procedures are carried out in the setting mode.
• Use the arrow keys to move the cursor (blue) to the appropriate parameter. (The
parameters that cannot be changed are grayed.)
• The possible selections are displayed at the bottom of the screen. Select using the
soft keys.
• The parameter boxes that are changed are displayed in yellow. By confirming the
new settings, they change back to white.
Press
To display the setting screen press the soft key
2
The numbers in front of the operating procedure shown below correspond to the
numbers in the above figure.
1.
2.
3.
4.
Note
Span lower limit and span upper limit cannot be set to the same value.
Confirming operation
To confirm the new settings, press the DISP/ENTER key.
To cancel the new settings, press the ESC key. A window appears for you to confirm the
cancellation. Select [Yes] using the arrow keys and press the DISP/ENTER key.
MENU .
1
4
3
First channel and last channel
Select the desired channels.
Mode
Set the mode to [DI].
Range
Select [Level] or [Cont] (Contact).
Upper and lower limits of span
Set the upper and lower limits of the display span.
Pressing the [Input] soft key displays a window used to enter a numerical value.
Enter 0 or 1 and press the DISP/ENTER key.
For the procedures related to entering numerical values, see "Entering
Numbers" on page 3-21.
#1
.
5
5-5