Omega RD-MV100 Series User Manual page 106

Chapter 5 Measurement Channel Settings
5.1 Voltage Input Setting
To measure the DC voltage input or the DC current input using an external shunt
resistor, follow the procedures below to set the voltage input. The range cannot be
changed while data acquisition or computation is in progress.
Procedure
• These procedures are carried out in the setting mode.
• Use the arrow keys to move the cursor (blue) to the appropriate parameter. (The
• The possible selections are displayed at the bottom of the screen. Select using the
• The parameter boxes that are changed are displayed in yellow. By confirming the
Press
To display the setting screen press the soft key
The numbers in front of the operating procedure shown below correspond to the
numbers in the above figure.
Note
Confirming operation
To confirm the new settings, press the DISP/ENTER key.
To cancel the new settings, press the ESC key. A window appears for you to confirm the
cancellation. Select [Yes] using the arrow keys and press the DISP/ENTER key.
parameters that cannot be changed are grayed.)
soft keys.
new settings, they change back to white.
MENU .
1
2 4
3
1. First channel and last channel
Select the desired channels.
2. Mode
Set the mode to [Volt].
3. Range
Set the input range.
4. Upper and lower limits of span
Set the upper and lower limits of the display span.
Pressing the [Input] soft key displays a window used to enter a numerical value.
Enter a value in the allowed range and press the DISP/ENTER key.
For the procedures related to entering numerical values, see "Entering
Numbers" on page 3-21.
Span lower limit and span upper limit cannot be set to the same value.
#1
.
5-1
5