Omega RD-MV100 Series User Manual page 67

3.3 Inserting/Removing the External Storage Medium
Explanation
3-6
2. Open the front cover by pressing down on the knob that is located in the center
of the upper section of the cover and pulling forward. Push the eject button to
remove the storage medium.
3. Close the front cover. If the RD-MV100 is turned ON, the external storage
medium icon in the status display section disappears (see the figure of the icon
on the previous page).
Floppy disk
Note
If the key lock function for the storage medium is engaged, the Zip disk cannot be ejected
even if the eject button is pressed. Release the key lock before attempting to eject the Zip
disk.
Procedure when the Zip disk cannot be ejected
If the Zip disk cannot be removed by performing the steps given in the "Removing the
storage medium" section, carry out the following steps to remove it.
1. Open the front cover by pressing down on the knob that is located in the center
of the upper section of the cover and pulling forward.
2. Insert a pin of approx. 1 mm in diameter into the eject button hole and press
slowly. This will cause the Zip disk to be ejected.
Eject button of the Zip drive
Zip disk eject hole
Insert
Pin
Formatting external storage media
Format the external storage medium before use.
The external storage medium is formatted to the following types using the recorder.
Format type
Floppy disk : 2 HD, 1.44 MB
Zip disk : FDISK 1 partition (hard disk format)
ATA flash memory card : FDISK 1 partition (hard disk format)
External storage media formatted on other devices can be used as long as the format
type is the same as those indicated above.
Zip disk ATA flash memory card