Omega RD-MV100 Series User Manual page 152

7.10 Setting the Scale Division, Bar Graph Base Position (Bar Graph), and Scale Position (Trend)
7-18
Scale values
The scale values are displayed at all main scale marks when the scale is divided into 4
to 7 sections using the main scale marks. When the scale is divided into 8 to 12
sections, the scale values are displayed at every other main scale mark.
In addition, the upper or lower limit of the scale is displayed at the end of the scale.
Rule 1 Up to 3 digits excluding the minus sign can be displayed for the scale values.
Rule 2 If the integer section of either value at the end of the scale is less than or equal
to one digit, the value is displayed as
Example 1 If the scale is set to –0.05 to 0.5, the scale display for the upper
and lower limits is –0.0 to 0.5.
Example 2 If the scale is set to –0.005 to 0.05, the scale display for the upper
and lower limits are –0.0 to 0.0.
Rule 3 If the integer section of either value at the end of the scale is greater than or
equal to two digits and less than three digits, the value is displayed with the
decimal fraction is discarded.
Example 3 If the scale is set to 0.1 to 100.0, the scale display for the upper
and lower limits is 0 to 100.
Rule 4 If the integer section of either value at the end of the scale is greater than or
equal to four digits, a three-digit mantissa and exponent are displayed (×10 or
×10 2
, for example).
Example 4 If the scale is set to 10 to 2000, the scale display for the upper
and lower limits are 0 to 200 × 10.
Rule 5 If the difference in the number of digits between the upper and lower limits of
the scale is larger than the number of digits that can be displayed, the smaller
value is set to zero (0 or 0.0).
Example 5 If the scale is set to –0.0005 to 0.5000, the upper and lower limits
of the scale are displayed as 0.0 to 0.5.
Unit
The unit is displayed near the center of the scale. When the partial expansion display is
used, the position will be shifted.
When the trend is displayed horizontally, the number of characters that can be displayed
is up to 4.
The unit is not displayed if the resolution of the measuring range is less than the number
of scale divisions using small marks.
or 0 .
. .