Setting The Report Function - Omega RD-MV100 Series User Manual

11.13 Setting the Report Function

Procedure
11-26
Set the report type, report channels, the time and date to create the report. The report
function is set in the basic setting mode.
• These procedures are carried out in the basic setting mode.
• Use the arrow keys to move the cursor (blue) to the appropriate parameter.
• The possible selections are displayed at the bottom of the screen. Select using the
soft keys.
• The parameter boxes that are changed are displayed in yellow. By confirming the
new settings, they change back to white.
Press MENU .
Press FUNC for 3 seconds. The menu screen for the basic setting mode appears.
Twice press the soft key
#9
Press the soft key
To display the setting screen press the soft key
The numbers in front of the operating procedure shown below correspond to the
numbers in the above figure.
1. Report set
[Hour] : Creates hourly reports.
[Day] : Creates daily reports.
[Day+Week] : Creates daily and weekly reports.
[Day+Month] : Creates daily and monthly reports.
2. Date/Day of the week
This is the date or day of the week on which the report is created.
If the [Report set] is set to [Day+Month], [Date] is displayed. If [Day+Week] is
specified, [Day] is displayed. If [Hour] or [Day] is specified, [Date] is displayed.
However, this setting is void.
• Date (for monthly reports)
Pressing the [Input] soft key displays a window used to enter the date. Enter
the date (01-28)* and press the DISP/ENTER key. Procedures related to
entering numerical values, see "Entering Numbers" on page 3-21.
* You cannot specify 30 or 31.
• Day (for weekly reports)
Enter the day of the week using the soft key.
Next 1/3
.
.
1
2
3
4
5
6
7
#2
.