Omega RD-MV100 Series User Manual page 65

3.2 Turning ON/OFF the Power Switch
Procedure
3-4
This section describes the procedures to turn ON/OFF the power switch.
1. Check the following points before turning ON the power switch.
• The power cord/wires are connected correctly to the recorder.
• The recorder is connected to the correct power supply. (See section 14.7)
• The proper fuse is set.
If the input wires are connected in parallel with another instrument, avoid turning
ON/OFF the recorder or the other instrument when either one is in operation.
This may affect the reading.
2. Turn the power switch ON.
After performing a self-diagnosis for a few seconds, a screen in the operation
mode appears.
Note
• If nothing is displayed when the power switch is turned ON, turn OFF the power switch and
check the points listed in step 1. After checking the points, turn ON the power switch again.
If the unit still does not work, it is probably malfunctioning. Contact Omega for repairs.
• If an error message is displayed on the screen, take measures according to the description in
chapter 12, "Troubleshooting."
• Turn ON the power switch, let the RD-MV100 warm up for at least 30 minutes, and then start
the measurements.
CAUTION