Omega RD-MV100 Series User Manual page 207

10.4 Setting the Key Login/Logout Functions (Basic Setting Mode)
6. User name
Enter the user name (up to 16 alphanumeric characters).
Pressing the [Input] soft key displays a window used to enter a string. Enter the
string and press the DISP/ENTER key. For the procedures related to entering
character strings, see "Entering Characters" on page 3-22.
Note
• For models with the batch function (/BT1 option), duplicate user names cannot be registered.
See "Confirming operation" below.
• "quit" cannot be used as the user name.
• All spaces are also not allowed for the user name.
7. User ID
Enter the user ID (up to 4 alphanumeric characters).
Pressing the [Input] soft key displays a window used to enter a string. Enter the
string and press the DISP/ENTER key. For the procedures related to entering
character strings, see "Entering Characters" on page 3-22.
8. Password
Enter the password (up to 6 alphanumeric characters).
Pressing the [Input] soft key displays a window used to enter a string. Enter the
string and press the DISP/ENTER key. For the procedures related to entering
character strings, see "Entering Characters" on page 3-22.
Note
For models with the batch function (/BT1 option), the combinations of user IDs and
passwords that are identical to those that have been registered by any user in the past cannot
be specified. See "Confirming operation" below.
9. Enter setup
Select whether or not to allow the login user to enter the basic setting mode.
[Enable] : The user can enter the basic setting mode.
[Disable] : The user can not enter the basic setting mode.
Note
The [Enter Setup] of all users cannot be set to [Disabled]. If specified, the user with the
lowest registration number with the fifth parameter turned [On] is automatically set to
[Enabled] (The setting is changed when the setup data is stored and the basic setting mode is
terminated.).
Confirming operation
To confirm the new settings, press the DISP/ENTER key.
• For models without the batch function (/BT1 option)
• If the user name already exists, a confirmation message "This username is already
registered," is displayed. At this point the user name is confirmed (confirmed but
not yet registered). If necessary, change the user name to be registered. Press the
DISP/ENTER key to register the user name.
• For models with the batch function (/BT1 option),
• If the user name already exists, an error message "This username is already
registered," is displayed. The user name entry box stays yellow, and the user
name is not registered. Change the user name to be registered.
• If the combination of the user ID and password already exists, an error message
"Duplicate used combination of user ID and password," is displayed. Change the
combination of the user ID and password to be registered.
To cancel the new settings, press the ESC key. A window appears for you to confirm the
cancellation. Select [Yes] using the arrow keys and press the DISP/ENTER key.
10
10-7