Omega RD-MV100 Series User Manual page 154

7.11 Using Partial Expansion Display (Trend)
Procedure
7-20
By compressing a section of the display scale of the measured/computed data, the
remaining section of the display is expanded. For detail, see section 1.3.
To use the partial expansion display, first, set the partial expansion display to [Use] in the
basic setting mode. This will display a partial expansion display setting box in the setting
mode (see section 7.12).
• These procedures are carried out in the setting mode.
• Use the arrow keys to move the cursor (blue) to the appropriate parameter. (The
parameters that cannot be changed are grayed.)
• The possible selections are displayed at the bottom of the screen. Select using the
soft keys.
• The parameter boxes that are changed are displayed in yellow. By confirming the
new settings, they change back to white.
Press MENU .
Next 1/3
Press the soft key
#5
Press the soft key
Setting on a measurement channel
To display the setting screen press the soft key
Setting on a computation channel (option)
To display the setting screen press the soft key
1
The numbers in front of the operating procedure shown below correspond to the
numbers in the above figure.
1. First channel and last channel
Select the desired channels. (For the channels set here, [Zone] and [Graph] are
also simultaneously set.)
2. On/Off
When [On] is selected, the [Expand] and [Boundary] boxes are displayed.
On : Use the partial expansion display.
Off : Not use the partial expansion display.
3. Expand (Boundary displacement position)
Set the position to which a particular value (the boundary, see step 4) in the
display span is to be moved as a percentage of the display span.
Pressing the [Input] soft key displays a window used to enter a numerical value.
Enter the position and press the DISP/ENTER key. For the procedures related
to entering numerical values, see "Entering Numbers" on page 3-21.
The range for the position : 1 to 99
.
.
#3
#6
2
3
4
.
.