Omega RD-MV100 Series User Manual page 181

8.10 Setting the Channels to Display the Trend and
Acquire the Data (Basic Setting Mode)
Procedure
Explanation
8-22
Select the channels for which the trend is to be displayed. The measured and computed
data of these channels can be acquired.
The waveforms for the channels that are turned OFF are not displayed, but numerical
values, bar graphs and alarms are displayed.
• These procedures are carried out in the basic setting mode.
• Use the arrow keys to move the cursor (blue) to the appropriate parameter.
• The possible selections are displayed at the bottom of the screen. Select using the
soft keys.
• The parameter boxes that are changed are displayed in yellow. By confirming the
new settings, they change back to white.
Press .
MENU
Press FUNC for 3 seconds. The menu screen for the basic setting mode appears.
To display the setting screen press the soft key
The numbers in front of the operating procedure shown below correspond to the
numbers in the above figure.
1. Meas CH/Math CH
To set the measurement channels, select [Meas CH]. To set the computation
channels, select [Math CH].
2. First channel and last channel
Select the desired channel numbers.
3. On/Off
On : Display the trend
Off : Do not display the trend
The initial setting is [On] for all channels.
Confirming operation
To confirm the new settings, press the DISP/ENTER key.
To cancel the new settings, press the ESC key. A window appears for you to confirm the
cancellation. Select [Yes] using the arrow keys and press the DISP/ENTER key.
The number of measurement and computation channels available in the different
models
Model Measurement Channel
RD-MV102 2 channels (1 to 2)
RD-MV104 4 channels (1 to 4)
RD-MV106 6 channels (1 to 6)
RD-MV112 12 channels (1 to 12)
#4
.
1
2
3
Computation Channel
4 channels (31 to 34)
4 channels (31 to 34)
12 channels (31 to 42)
12 channels (31 to 42)