Choose the type of machine
that profiles are to be copied to
by moving the cursor to the
appropriate line using the
''UP" and "DOWN" arrow
keys. Select 'Specific
Machine' to choose to which
machine the profile should be
sent. Selecting 'Specific
Machine' will present the
screen shown in the next step,
else the screen shown in
Figure 152 will be displayed.
Selecting 'Abort' or pressing
"EXIT" will return to the
profile selection screen
Figure 150: Machine Type
without copying the profile.
NOTE: Even though it is possible to retrieve a profile from one machine type and then store it at a
machine of a different type, the operator should be aware that the profiles may not be compatible.
This screen is shown only if
'Specific Machine' was chosen
in the previous step. Use the
arrow keys to highlight the
machine to which the profile
should be sent. Press
"ENTER" to continue to the
next step, or "EXIT" to abort
and return to the profile
selection screen.
Figure 151: Select Specific Machine
84 Sentry Control System