Profiles; Edit Profiles; Figure 17: Profiles; Figure 18: Edit Profiles - Jamesway Sentry Manual

3.4 Profiles

Selecting the 'Profiles' menu
displays a submenu, allowing a
profile to be edited or started
on a specific machine. A profile
allows an operator to program
the machine to automatically
make setpoint changes at
predetermined times in an
incubation cycle. Each machine
can store up to 20 different
profiles, each of which can
have up to 30 different program
steps. 'Edit Profile' allows an
operator to retrieve a profile
from the machine, make
changes to it, and then store
the changes at the machine.
'Start Profile' is used to tell the machine which profile to use, and when to start it.

3.4.1 Edit Profiles

Selecting 'Profiles' from the
Machine menu displays the
Profiles submenu, allowing the
operator to edit a profile or
start a profile. Moving the
cursor to the desired function
using the "UP" and "DOWN"
arrow keys and then pressing
"ENTER" activates the
selected function. Refer to the
Network Edit Profile section on
Page 77 to change profiles on
more than one machine at a
time.

Figure 17: Profiles

Figure 18: Edit Profiles

Sentry Control System 17