Figure 15: Duration Of Dryout; Figure 16: Send Dryout Time - Jamesway Sentry Manual

If the machine was in normal
mode, the operator is asked to
input the desired duration of
time for the dry out function.
Valid time ranges from 0 to 99
minutes. The default value
displayed can be used by just
pressing "ENTER", or a new
value can be entered using the
numeric digits and then
pressing "ENTER".
Pressing "EXIT" brings up the
previous screen without
changing the mode of the
machine.
The operator must either abort
the action or change the dry
out mode. If the machine is not
in dry out mode (i.e. "Normal"
mode) it will go into dry out
by toggling the mode. If it is in
dry out mode, then selecting
'Change Dry out Mode' will
instruct the machine to cancel
dry out operation and go into
"Normal" mode.
NOTE: The system will not
allow a machine to be placed
in dry out mode if the
temperature of the machine is
above 90°F (32°C). With
software version 1.23 and
above, the operator may proceed even if the temperature is above 90°F (32°C).
16 Sentry Control System

Figure 15: Duration of Dryout

Figure 16: Send Dryout Time